Troubleshooting Chart - Sharp AX-600X(R) Operation Manual

TROUBLESHOOTING CHART

If EE is displayed or you think the oven is not working properly, check the chart below before consulting a SER-
VICE CENTRE APPROVED BY SHARP. This will help to prevent unnecessary service calls.
WARNING:
Never adjust, repair or modify the oven by yourself. It is hazardous for anyone other than a qualified
service technician trained by SHARP to carry out any service or repair operation. This is important as
it may involve the removal of covers that provide protection against electrical parts.
• Repairs and Modifications: Do not attempt to operate the oven if it is not working properly.
• Outer cabinet & Lamp Access: Never remove the outer cabinet to avoid the possibility of electric shock or burns.
Troubleshooting Chart
ERROR MESSAGE / INFORMATION MESSAGE
MESSAGE ON DISPLAY
ERROR EE
MESSAGE
INFORMATION Wait.
MESSAGE Oven is too warm to use.
Water is frozen.
Please refer to instructions in
operation manual.
Now cooling.
Replace drip tray.
Empty drip tray and replace.
Descaling is necessary.
Fill water tank with water.
Remove water tank
Hot
ACTION
Due to technical error, contact a SERVICE CENTRE
APPROVED BY SHARP.
The oven is too hot to use Microwave for defrosting or Steam
Manual Proof. Remove food from oven and allow to cool
until the message clears.
The oven may not operate properly.
Operate the oven with Convection Grill without food and
preheat for 5 minutes.
See page E-17.
After cooking, the oven and the parts will be hot.
Now cooling is shown in the display until the oven cavity
has cooled. The cooling fan may continue to operate up to
13 minutes.
Now cooling will disappear when the oven has cooled.
If you wish to use the warm oven, simply press Stop/Clear.
Remove and replace the drip tray correctly.
See page E-6.
In case the drip tray is not installed correctly, Replace drip
tray will be shown in the display.
Empty drip tray and replace will be shown in the display
when water remains in the drip tray. You must empty the
drip tray and replace it before SuperSteam Convection or
Steam Cooking will start. See page E-6.
Follow step-by-step instructions for descaling.
See page E-8.
Remove water tank and fill with water to the 2 mark (MAX
mark). Replace and push firmly into place.
NOTE: Ensure you do not use any other liquids like distilled
water, R.O water, meneral water and etc.
If water is in the water tank, Drain Water function will not
start. Remove the water tank before starting Drain Water.
The oven cabinet and oven cavity are very hot.
Pay extra attention not to burn yourself.
E – 26