GE JV535 Owner's Manual And Installation Instructions page 10

REMOVE EXHAUST ADAPTOR
2
Remove the 7" round exhaust adaptor from the top of
the hood. Set it aside along with its mounting screws.
NOTE: Save the screws for 3¼" x 10" rectangular
ducted installation, if that is your chosen venting option.
7" round
exhaust
adaptor
3 REMOVE FILTERS
Remove the protective shipping film from the edges
of the metal grease filters. Press the filter locks back
and lift the filters out. Set them aside.
Filters
1 Ft = 0.3 m
1" = 2.5 cm
Installation Instructions
10
REMOVE WIRING COVER
4
FROM THE JUNCTION BOX
Remove the wiring cover from inside the hood.
Set the cover and its mounting screw aside.
Wiring
cover
REMOVE WIRING KNOCKOUT
5
Remove either the top or the back wiring knockout as
needed and install an approved strain relief clamp.
Strain relief
clamp