Table of Contents
Advertisement
remote control sensor disable
1.
Arm the system.
2.
Use the transmitter to bypass the sensor by pressing the "lock/unlock button"
and "trunk release button" at the same time.
3.
The lights will flash four times. All warn away zones are now bypassed.
4.
Transmit the sensor bypass channel again.
5.
The lights will flash four times again. The sensor warn away and full trigger
zones are now bypassed.
6.
The sensor zones will reset when disarmed.
troubleshooting
Starter kill does not work.
Is the correct starter wire being interrupted? If the car starts when the starter kill
relay is completely disconnected, the wrong starter wire has been cut and inter-
rupted.
Is the YELLOW wire seeing true ignition? Is it connected to an accessory circuit?
Has the no/nc feature been changed?
Shock sensor does not trigger the alarm.
Has the FACT II system been triggered? To check this, turn the ignition key on
and off to clear the FACT II from memory, and then retest the shock sensor. For
a detailed description of FACT II, see the FACT II: False Alarm Control
Technology section of this guide.
Closing the door triggers the system, but opening the door does not.
Have you correctly identified the type of door switch system? This happens often
when the wrong door input has been used.
The system will not passively arm until it is remotely armed and then disarmed.
Are the door inputs connected? Is a BLUE wire connected to the door trigger wire
in the vehicle? Either the GREEN H1/9 or the VIOLET H1/8 should be used
instead.
34
www.directed.com
Hide quick links:
Advertisement
Table of Contents
