Clifford Arrow 5.1 Installation Manual page 33

Disarm: The accessory output will auto-activate when the system is disarmed.
Both: The accessory output will auto-activate when the system is armed and
disarmed.
accessory output timer duration
Start Timer: Press the arm/disarm button; the siren will chirp to signal the start
of the timer duration setting.
Stop Timer: Press the arm/disarm button; the siren will chirp to signal the end of the
timer duration setting, or for maximum time, do not press the arm/disarm button.
interrupt no/nc
NO: If the starter immobilizer circuit is normally open and power is lost to the
system, the circuit will remain open and the starter will not operate.
NC: If the starter immobilizer circuit is normally closed and power is lost to the
system, the circuit will close and the starter will operate normally.
rpm programming
This feature applies only if IntelliStart 4 is installed.
Programs the tachometer input for the IntelliStart 4. For more information, see
programming note #4.
engine type gas/diesel
This feature applies only if IntelliStart 4 is installed.
Petrol: The IntelliStart will crank the engine three seconds after the ignition is
turned on or after input on the wait-to-start wires ceases.
Diesel: The IntelliStart will crank the engine 20 seconds after it turns the ignition
on and will ignore the wait-to-start input wires.
N N O O T T E E : : RPM must be reprogrammed after changing this feature.
smart windows program
This feature applies only if SmartWindows is installed.
Enter this feature and then follow the programming instructions included with
SmartWindows.
30
www.directed.com