Clifford Arrow 5.1 Installation Manual page 8

h1/1 black ground
Connect the BLACK wire to a clean, paint-free sheet metal location (driver's kick panel)
using a factory bolt that does NOT have any vehicle component grounds attached to
it. A screw should only be used in conjunction with a two-sided lock washer. Under
dash brackets and door sheet metal are not acceptable ground points. It is recom-
mended that all security components be grounded at the same location.
h1/7 blue (-) hood/trunk trigger input - zone 5
This input will respond to a negative input with an instant trigger. It is ideal for hood
and trunk pins and will report on Zone 5. It can also be used with Directed single-
stage sensors.
h1/8 violet (+) door trigger input - zone 4
Connect the violet wire to a wire that shows (+)12V when any door is opened. This
wire will report Zone 4.
5
© 2006 directed electronics