System Status Chirps; Multiple Event Total Recall - Clifford Arrow 5.1 Installation Manual

system status chirps

Action No. of Chirps
Arm
Arm
Arm 2 (5-second pause) 4
Arm 2 (10-second pause) 4
Disarm
Disarm
Disarm

multiple event total recall

This will report the last eight system triggers.
1. Press and hold
2. While still holding
3. The LED will start to blink to indicate the most recent trigger and proceed down
to the eighth trigger. If fewer than eight triggers are stored in memory, the LED
will blink continuously until the system is armed/disarmed using the transmitter
after recalling the final trigger. For more information, please refer to the Table of
Zones section of this guide.
© 2006 directed electronics
Description
2 System armed.
4 System armed with hood and
trunk bypass zones 5 and 6.
System armed with door bypass zones
System armed with sensor active
and bypassed zones 3 and 8.
1 System disarmed.
3 System disarmed with zone violation
5 System disarmed transmitter low battery
of the PlainView 2 Valet switch.
, arm and disarm the system, then release the button.
21