Performax 240-3724 Operation And Safety Instructions page 6

Specific safety rules for the scroll saw (continued)
When operating the scroll saw
1. To avoid injury from unexpected scroll saw movement:
• Use the scroll saw on a firm level surface with adequate space for handling and
supporting the work piece.
• Be sure the scroll saw cannot move when operated. Secure the scroll saw to a workbench
or table with wood screws or bolts with washers and nuts.
2. Before moving the scroll saw, unplug the power cord from the electrical outlet.
3. To avoid injury from kickback:
• Hold the work piece firmly against the tabletop.
• Do not feed the work piece too fast while cutting. Only feed the work piece at the rate
the saw will cut.
• Install the blade with the teeth pointing downward.
• Do not start the saw with the work piece pressing against the blade. Slowly feed the
work piece into the moving blade.
• Use caution when cutting round or irregularly shaped work pieces. Round items will roll
and irregularly shaped work pieces can pinch the blade.
4. To avoid injury when operating the scroll saw:
• If you are not thoroughly familiar with the operation of scroll saws, obtain advice from a
qualified person.
• Before starting the saw, make sure the blade tension is correct. Recheck and adjust
tension as needed.
• Make sure the table is locked into position before starting the saw.
• Do not use dull or bent blades.
• When cutting a large work piece, make sure the material is supported at the table height.
• Turn the saw OFF and unplug the power cord if the blade jams in the work piece while
being backed out. This condition is usually caused by sawdust clogging the line you are
cutting. If this happens, turn OFF the scroll saw and unplug the power cord. Wedge open
the work piece and back out the blade.
6