Clifford 10.5X Installation Manual page 9

IMPORTANT! Never use this wire to drive anything but a relay or a low-current input!
This transistorized output can only supply 200 mA, and connecting directly to a
solenoid, motor, or other high-current device will cause the module to fail.
H1/11 WHITE (+/-) 10 A parking light flash output
The H1/11 WHITE wire is factory configured for (+) parking lights. Refer to the Programming
Jumper section of this installation guide for changing configuration for (-) parking light.
N N O O T T E E :
For parking light systems that draw 10 amps or more, the jumper must be switched to a (-) light
Programming Jumpers
flash output (see the
motive SPDT relay must be used on the H1/11 light flash output wire.
IMPORTANT! DO NOT connect this wire to a negative vehicle light flash wire before
changing the programming jumper to the negative polarity position or damage to
vehicle light circuit may occur.
NOTE: A dual diode harness assembly is provided (Viper model only) for European
vehicles which have parking light capability for illumination of only the parking lights on
the side of the vehicle to the road when parked.
H1/12 ORANGE (-) ground-when-armed output
This wire supplies a (-) ground as long as the system is armed. This output ceases as soon as the
system is disarmed. It can supply up to 500 mA of current.
© 2005
Directed Electronics, Inc.
section of this guide). P/N 8617 or a standard auto-
9