Table of Contents
Advertisement
LOW HEIGHT 24
STEP 8:
• Insert three 1-3/4" SQ. END CAPS (23) into the ends of the LEG EXTENSION (8) as shown in FIGURE 8.
• Insert two 1/2" FLANGE BEARINGS (26) into the BUSHING on the LEG EXTENSION (8) as shown in FIGURE 8.
• Assemble the LEG EXTENSION (8) to the LEG EXTENSION NECK (7) as shown in FIGURE 8, using one 1/2 X 3" BOLT (18),
two 1/2" WASHERS (22), and one 1/2" LOW HEIGHT LOCK NUT (24). (TIGHTEN THE CONNECTION ENOUGH TO
REMOVE THE PLAY, YET ALLOWING THE LEG EXTENSION TO ROTATE FREELY)
• Assemble four ROLLER PADS (12) to the LEG EXTENSION (8) as shown in FIGURE 8, using two ROLLER PAD SHAFTS (11),
and four 3/4" STARLOCK COLLARS (27).
• Attach one 3/4" SQ. RUBBER BUMPER (32) to the LEG EXTENSION (8) approximately where shown in FIGURE 8.
22
7
32
18 1/2 X 3"
26
8
13
27
12
11
23
FIGURE 8
Advertisement
Table of Contents
