Tascam M-200 Series Owner's Manual page 5

This output is then plugged into your reverb
unit and the reverb's outputs are connected to
either or both of the effect return (EFF R'rIV)
inputs on the back panel. So we see that the
Effect Sub-mix system lets you decide "How
EFF OUTPUT
Much? " reverb will be used on which channel
("where? ).
INPUT EOUALIZER FADER ASSIGN
"
\
F A
I
EFF
RTN
MASTER
L
STEREO. OUT
R
FADER
The Solo System gets i t s signals from the selected sources through the headphones. In
Main Mix channels. The Pre Fader Listen (PFL) recording applications, Solo i s used to adjust
switch in the channel sends that channel's TRIM, level and tone in an individua1 channel or
signal to the Solo Master Control. The PFL group of channels. In sound reinforcement, Solo
switch automatically bypasses the Monitor is very useful for setting levels and tone, as well
Select switches and sends the Solo Mix to the as for finding feedback and cable problems.
headphone jack. This lets the user listen to
\I
INPUT
I
EOUALIZER
I
FADER
I
ASSIGN
(
TO Monitor
Signals
SOLO
from
\
W
STEREO
Monitor
Select
with
MON Switches