Advertisement
Quick Links
TASCAM M-3500 MIXING CONSOLE
INPUT SECTION
The mixer is able to select two seperate user inputs, the
line input jack or the mic input jack. The line input
jack is a 1/4" female jack and the the mic input jack is
an XLR female jack (See figure 1). Figure 2 shows the
input section controls, the first section of the mixing
board. The red knob adjusts the input level from the
Figure 1
mic input jack and the gray knob adjusts the input level
from the line input jack. If these knobs do not reduce
the input level enough, the "PAD" button can be
pressed to reduce the level by -30 dB. Pressing the
"LINE" button selects the line input jack. If it is not
depressed, the mic input jack is selected.
The "PWR" button activates the phantom power on the
mic input jack. The "FLIP" button will retard the
phase of the input by 180 degrees. The "HPF" button
is used to activate a high pass filter for the mic input
jack, in order to compensate for proximaty effects.
Figure 2
1
Advertisement
Related Manuals for Tascam M-3500
Summary of Contents for Tascam M-3500
- Page 1 TASCAM M-3500 MIXING CONSOLE INPUT SECTION The mixer is able to select two seperate user inputs, the line input jack or the mic input jack. The line input jack is a 1/4” female jack and the the mic input jack is an XLR female jack (See figure 1).
- Page 2 TASCAM M-3500 MIXING CONSOLE EQUILIZER SECTION Each channel has a seperate equilizer section to adjust the levels of certain frequencies on that channel. To activate this section, press the “EQ” button so that the green LED is lit (See figure The high and low frequency eqs are graphic, set to 10 kHz and 100 Hz, respectively.
-
Page 3: Studio Monitor Section
TASCAM M-3500 MIXING CONSOLE STUDIO MONITOR SECTION Each channel has the capability of sending a copy of itself to the Isolation Booth, otherwise known as the Studio. This can be independant of the Control Room sound, or be a copy of it, depending upon the settings of the monitor section. - Page 4 TASCAM M-3500 MIXING CONSOLE CHANNEL FADER SECTION The FADERS allow easily adjustable control of the amplitude of each individual channel. Based upon earlier “PRE” and “POST” selections, this can effect other sections, such as the MONI- TOR, AUX and BUS signals.
-
Page 5: Oscillator Section
TASCAM M-3500 MIXING CONSOLE BUS FADER SECTION The BUS FADERS and STEREO FADER allow easily adjust- able control of the amplitude of each bus and the stereo output. Each fader is marked to show the 0 dB level settings. To adjust the input gain structure, each fader should be set to 0 dB. -
Page 6: Control Room Section
TASCAM M-3500 MIXING CONSOLE The following controls only change the listening sources/environment, without effecting the output signal(s). CONTROL ROOM SECTION This section allows the engineer to change what is being heard in the CON- TROL ROOM. The buttons select the signal being heard. The first six (6) buttons allow the engineer to hear what is being sent to any of the six (6) AUX SENDS. -
Page 7: Talk Back Section
The TASCAM M-3500 MIXING CONSOLE is an inline recording mixer, designed to support 8, 16, and 24 channel recording requirements, as well as to support a studio, control room and stereo output environment, up to +6 dB recording levels.