Tascam M-200 Series Owner's Manual page 24

(DPGM Master (Group) Faders 1
-
4
These faders vary the amount of signal that
i s sent on the Master PAN controls and PGM
MASTER OUTputs after it is received from the
Buss Assignment onloff buttons.
@PGM Master METERS 1
-
4
These meters give you a visual representation
of the signal level as
it
appears
a t
the PGM
MASTER OUTputs and Master PAN controls.
The METERS will show you two conditions:
the average signal level, which is shown by the
needle, and the peak or transient program level,
which is shown by a PEAK Light.
OPGM OUTputs
There are three outputs for each of the four
PGM busses. An XLR connector provides an
unbalanced output. Two RCA parallel connectors
with line' level signals are available for each buss.
These are usually used to feed tape recorders.
(D
Master PAN Controls
These rotary controls accept signal from the
PGM Master Faders and determine the amount
of signal that will be passed along to the left
and right sides of the STEREO Buss.