Tascam M-200 Series Owner's Manual page 25

OSUB Buss I Nputs
A stereo tape recorder, video recorder or
other source may be connected
a t
this point in
the mix. I t is also possible to "stack" or "cas-
cade" mixers by using the SUB Buss INputs to
bring the stereo outputs of another mixer into
your Series 200. The connectors, located on the
back panel, are RCA type.
@Stereo Master Faders L and R
These faders vary the signal level that they
receive from the Stereo Buss (a mixture of
signals from PGM 1
-
4, SUB Buss INputs,
and EFFect ReTurlV 1 and 2). The signal goes to
the STEREO OUTputs and R/L OUTPUTS.
@STEREO OUTputs and R/L OUTPUTS
'rhese are the outputs that you will use to
feed your main power amp and speakers, if
you're using the 200 for sound reinforcement.
The STEREO OUTputs use XLR connectors and
provide an unbalanced signal. The R/L OUTPUTS
use quarter-inch phone connectors and supply
an unbalanced signal. You will also use these
outputs for your stereo remix during audio or
video mastering.
8 M O N O Button
This button is located just above the SOLO
Level control. I t is used to override your stereo
mix, placing the same monophonic mix a t al1
stereo outputs and the stereo headphone output.
A mono rnix is used t o discern phasing problems
and for mono sound reinforcement applica-
tions.
MONITOR SECTION
@METER 3-4IMONitor Switch
This switch affects the 3/L and 4/R meters.
I t determines whether the meters display the
signal level on the numbers 3 and 4 PGM Busses,
or whether the meters will read the signals
determined by the MONitor Select Switch in-
cluding: the STEREO Master, FoLdBack, or
EFFect mix.
@
MONitor
This is a level control for the MONITOR sec-
tion. The MONitor Level controls the volume
level
a t
the Headphone jack on the front panel.
@
MONitor Select Switches
STEREO
If the METER button is in the MONitor posi-
tion, pressing the STEREO button will allow
the 3/L and 4/R meter t o display the signals as
they appear
a t
the STEREO OUTputs. This also
switches the Headphone jack to the same source.
FLB (Foldback)
With the METER button in the MONITOR
position, the FLB button will switch the meters
to display the foldback mix. The foldback rnix
will also be available
a t
the Headphone jack.
EFFECT
If the METER button is down, pressing the
EF F ECT button will cause the meters to display
the effect rnix signals. I t will also make the
effect mix available
a t
the Headphone jack.