Table of Contents
Advertisement
Fig 4-13 New Job
If there is a job file existing, close this existing file, then create a new job. After filling all the
items, click "OK" to enter program.
2. Add observation files
The input method of Differential data is the same as static. Click " Add GPS observation file"
from " Input",or after adding observation file shortcut key, select the observation data from
the coming out file-select dialog box, click " OK" to complete the import work. The demo data
of
the
software
defaults
the
path
"C:\Program
Files\KRONOS\KRONOS
PROCESSOR\Example\TRACK". Here select the collected file 8464273D.DAT and
84712739.DAT as example, data information is visible from the form of " Observation data "
when the file is imported. Please refer to the following figure 4-14:
Fig 4-14 Differential data
From the above figure, the data has been imported into the program.
3. Input the known coordinate of KRONOS100 Base station
Click " Station coordinate" from "Input" menu, and a dialog box comes out, shown as below:
Fig 4-15 Input known coordinate
The default coordinate value of the software is the single point geodetic coordinate set in the
" Project Setting", but what we usually need is the right-angle coordinate value, so input the
known right-angle coordinate value of the KRONOS100 in the coming out dialog box.
Note: Not only requires to input the plane right-angle coordinate, but also the Height value
while setting the KRONOS100 base coordinate
4. Differential processing and output network report
Click " tracking" from "Track" menu or click the Post differential processing shortcut key,
and the software will process the data automatically, showing the report as the following
figure:
30
Advertisement
Table of Contents
