Table of Contents
Advertisement
collecting interval to be 5 sec and set the times of collection points to be 3 times, it need a
surveying time of 15sec on every point.
How to set the KRONOS100-Rover in the field? Please refer to the following steps:
1. On the initial interface(Fig4-1), press F4 to select "TRK" mode, it will enter collection
interface shown as figure 4-2.
2. Press F2 [SET], shown as following, set the interval time , mask angle and track time,
then Press F4[OK] to return the former interface (figure 4-2)
3. When the condition is satisfied, please press F3 [MEAS], shown as following picture you
will see some information. Such as satellite, PDOP value, and so on.
Note: the collection condition is satisfied means position status is 3D, PDOP is less than 6.0 and
locked satellites are more than 4.
F1
F2
Fig 4-5 setting interface
F1
F2
F3
Fig4-6 Status interface
25
F3
F4
F4
Advertisement
Table of Contents
