MAN and LED. The detailed operations please refer to chapter three of 'KRONOS100 survey
system'.
After the KRONOS100 enters the data collection status shown as figure 4-3, the
KRONOS100-Rover can enter the surveying area to do differential survey.
Steps 2: KRONOS100 ROVER data-collection
Note: Ensure that both KRONOS100-Rover and KRONOS100-Base collect data at the
synchronization.
Only
KRONOS100-Rover can begin to collect data in the survey area.
Select tracking mode on the initial interface (Fig 4-1,press F4) to enter KRONOS100-Rover
data collection status.
Functions of keys:
:
[F1]
To set collection interval time.
The default interval is 5 seconds, means the epoch of record is 5 seconds.
[F2]: To set mask angle.
The default mask angle is 10 degrees. Press F1 continuously, the mask angle can be changed
from 0 degree to 45 degrees.
[F3]: To set the times of collection points.
It means that at one point, the receiver will record 3 times raw date. For example, if you set
F1
F2
Fig 4-3 KRONOS100 data collection interface
after
the
KRONOS100-Base
F1
F2
F3
Fig 4-4 KRONOS100-Rover setting interface
24
F3
F4
enters
data
F4
collection
status,