Horizon Fitness KRONOS100 Operation Manual page 19

b. Press F3 to enter point name input interface, you can name the logging data, input period
number and antenna height here, see as:
Note: The different between AUTO and MAN: In AUTO mode, the receiver names the data
when logging it, but in MAN mode, you should input the point name and press the key to
start log date.
3. End logging data:
Firstly, you should end to log the data, before you power off the receiver. Please refer to
figure 3-11, when the time is enough, you can press "F4" to end logging.
4. Power off receiver.
1). Use controller to operate the receiver back to the main interface and long press PWR key
on receiver to turn it off.
2). Switch to the interface as following figure, then press F2 to power off receiver.
F1 F2 F3
Fig 3-11 "survey" interface
F1 F2 F3
Fig 3-12 name interface
19
F4
F4