Table of Contents
Advertisement
6. After check, Press F1 [SAMP] to collecdata, see the picture as following:
After complete, you can hear a long beep, and the STATUS become SAMPLE 06/06. Then
take the KRONOS100-Rover to go another target to survey and follow the 5 and 6 steps
above.(In same surveying area, no need to move the KRONOS100-Base).
Special Tip:
1. For ensuring survey accuracy, please make sure receiver is fixed when initializing, and
please make sure your pole is level when collecting. Don't shake the mainframe.
2. Please note the value of cycle slip on the interface when colleting. If the value of cycle slip
is too big (more than 07), it should be initialized again.
Fig 4-9 Surveying interface
27
Advertisement
Table of Contents
