Water Tech POOL BLASTER CATFISH PPV Use And Care Manual page 5

USING YOUR CLEANER
CAUTION:
The cleaner is designed for underwater use only. Do not attempt
to use your cleaner to clean anything other than your pool or spa. It is not intended for use
as an all-purpose vacuum cleaner. Unit must be submerged in water to operate properly.
Maximum operating temperature is between +5DEGC (41˚F) and
+40DEGC (104˚F). Maximum operating depth is ?? meters (12 ft)
• Close supervision is necessary when used near children. Do not allow this vacuum cleaner to be used as a
toy.
• This vacuum creates suction. Keep hair, loose clothing, fingers, and all parts of body away from openings
and moving parts.
• Avoid picking up hard, sharp objects with the vacuum. They may damage the vacuum and the filter bag.
• Do not use without filter bag/seal ring and nose cap in place.
• Replace damaged filter bag/seal ring promptly.
• Do not use your cleaner to pick up toxic substances, flammable or combustible liquids such as gasoline, or
operate in the presence of explosive or flammable fumes.
• Never insert or drop any object into any opening on the device. Do not use with any opening blocked. Keep
all openings free of leaves, rocks, or anything that may reduce water flow.
• Do not use on or near hot surfaces.
• Use extra care when cleaning on stairs.
• When not in use, store the cleaner indoors in a clean, dry place. Do not leave in direct sunlight, underwater,
or exposed to extreme temperatures.
• In order for your cleaner to operate properly, both side vents must be submerged completely ( about 16" ).
Your cleaner is designed for use in 3 different ways to vacuum your
pool or spa:
A. Vacuum using the handle and the vacuum head removed.
B. Vacuum using the handle and attached vacuum head, with either wheel or brush attachments
depending on pool type.
C. Vacuum using a standard vacuum pole (not supplied) with the attached vacuum head.
A.
WARNING:
Never use your cleaner without the filter bag/seal ring
and nose cap properly in place. Doing so will VOID the warranty.
B. C.
Using a standard pole
The handle on your cleaner is designed to accommodate any standard pole. To attach a pole, simply press down on the
alignment pins on the pole retaining spring clip. Aligning the holes, slide the pole through the cuff, onto the cleaner and
release the clip.
WARNING:
Do not lean on pole or use pole to support weight.
WARNING:
Never put the cleaner in water while the charging jack is connected.
WARNING:
To keep water out of the motor box, before submerging make sure
the battery cap is fully secured by turning all the way until the arrow is aligned to the "lock"
symbol.
Once your cleaner is set-up for use, you may put it in your pool or spa.
• Bring your cleaner to the side of the Pool or Spa and turn it on by depressing the power button. This must be
done outside of the water before it is submerged.
• Once the cleaner is "On" it can be completely submerged in water and is ready for use.
• This appliance is designed to be in water only when in the "ON" position and has battery power. Excessive leak-
ing can occur when not running and void the warranty. Never leave your cleaner in the water when it is off.
WARNING:
If any parts are missing, do not operate until the missing parts are
replaced. Failure to do so could result in serious injury.
NOTE:
to remove the unit from the pool: Lift from pool with the nose facing up to allow the
water to escape from the back and sides.
NOTE:
The cleaner is only designed to vacuum water and will not vacuum air. The
cleaner will only work when completely submerged in water and the air is out of funnel.