Page 1
DO NOT RETURN THIS PRODUCT TO THE STORE Email: support@WaterTechCorp.com Should you have any problems or questions concerning your product you Www.WaterTechCorp.com should contact Water Tech’s Customer Service Division toll free at 1-800-298-8800. Pool Buster Owner’s Use & Care Manual...
However, it should be rinsed off with fresh water after it is amount of space is left open in the Pool Buster body. As a result, from removed from the pool. This will increase the life of the fi lter bag/seal ring.
Page 3
Do not operate your Pool Buster if water gets inside the machine. Put the “OFF” OR HAS RUN OUT OF BATTERY POWER. Pool Buster on its side to drain the water out of the knob hole and tilt side Do not use your Pool Buster for pool openings; the Pool Buster to side to get the water out.
Pool Buster is out of battery power? explosive or fl ammable fumes. A: Most people can feel the Pool Buster is running through vibration in the Never insert or drop any object into any opening on the device. vacuum pole or handle. To be sure you can lift it out of the water to hear if Keep all openings free of leaves, rocks, or anything that may it is running or not.
Damage or any failure caused by repair, which is done by anyone other than a Water Tech autho- The use of extension cords is not recommended. Plug the rized service center, shall not be covered.
Pool Buster body. As a result, from time to time, water may enter the unit. In order to allow for any water to be drained you should remove the On-Off Knob after each use, turn the ma- chine so the knob is towards the fl...
In the Nose Cap (Part No. PBA002) there is a Flapper Valve. To keep the Nose Cap Flapper Valve moving freely, clean the valve after every use. This will help to keep dirt inside the Pool Buster after the cleaner is removed from the pool.
CHARGING YOUR POOL BUSTER MAINTENANCE • Place the Pool Buster on its end (remove the vacuum pole, if The battery pack for your Pool Buster has been shipped in a low voltage attached). condition. It should be charged overnight prior to use. WARNING: The Pool Buster charger is for indoor use only.
Page 9
“Off” position before attempting to use your Pool !Caution: Buster. Replace On-Off knob after charging. Plac- ing Pool Buster in water without replacing the knob will void your warranty. ! WARNING: Using your Pool Buster without the fi lter bag/seal ring in place will VOID your warranty.
On/Off knob is fully secured by turning all the way until it stops at a 12 o’clock position. Once your Pool Buster is set-up for use, you may put it in your pool or spa. • Bring your Pool Buster to the side of the Pool or Spa and turn it on by turning the On-Off knob all the way to the “On”...
Page 11
HOW TO USE YOUR POOL BUSTER Your Pool Buster is designed for use in 3 different ways to Your Pool Buster has a unique patented vacuum head that can be adapted vacuum your pool or spa: to use on all types of pool surfaces. We recommend the following: A.
Place the Pool Buster on its end on a stable and secure surface. Do not attempt to use your Pool Buster to clean anything other than your pool or spa. It is not intended for use as an all-purpose vacuum cleaner.
Need help?
Do you have a question about the POOL BUSTER and is the answer not in the manual?
Questions and answers