4.10 Swim Mode; Chromis Pc Interface; Cradle - Accessory - SCUBAPRO-UWATEC Chromis User Manual

4.10 SWIM mode

It is sometimes practical to be able to
measure a distance at the surface, for
example when searching the dive site.
If your Chromis has the Surface Exercise
mode enabled, you can count your kick
cycles and measure the distance covered
during the exercise. Naturally, Chromis
must be
fi xed to your ankle so that kick counting is
possible.
Chromis can be set to SWIM mode from
any of the surface displays by long press +.
Naturally the SWIM mode must have been
activated from the corresponding menu.

NOTE: The SWIM mode operates
only on the surface. It will switch
automatically to active dive mode
when immersed deeper than 3m/10ft.
5.

CHROMIS PC INTERFACE

5.1 Cradle – accessory
Communication between Chromis and a PC/Mac is possible only with a cradle. A cradle can
be bought from your Authorized SCUBAPRO dealer.
The communication between the Chromis and the cradle is established via the contact on
the case. Therefore if the water contact or the spring contact of the cradle has dirt on the
surface, this should be cleaned with a piece of cloth before use
To avoid scratching of your Chromis, fi rst place contacts together and then click Chromis
to the cradle
CHROMIS USER MANUAL
In SWIM mode and during surface exercise,
Chromis displays the count of kicks on the
top row, the elapsed time on the middle row
and the converted distance on the bottom
row.
41