Setting The Alarm Clock; Setting The Utc; Setting The Time And 24H Or Am/Pm Mode; Set Dual Time Mode - SCUBAPRO-UWATEC Chromis User Manual

3.1.1

Setting the alarm clock

By pressing the SEL button the alarm status
will start blinking and can be selected to
either on or off by pressing + or - buttons.
By pressing the SEL button the hours of the
alarm will start blinking.
You can scroll the hours setting by pressing
+ or – buttons.
By pressing the SEL button the minutes
will start blinking and by pressing + or –
buttons you can scroll them.
Pressing the SEL button will confi rm the
settings.

NOTE: The sound off setting does not
affect the alarm clock. However, the
intelligent battery stretching algorithm
disables all warning tones when there
are less than 2 dots left in the battery
status display or when the battery
symbol is blinking in other displays.
3.1.2

Setting the UTC

The UTC setting will change the shown
time compared to Greenwich 0-Meridian.
This feature is practical when travelling
through different time zones.
10
By pressing SEL the hours will start blinking.
You may edit them with + or – buttons in
a range of +14h..-13h. By pressing SEL
the minutes will start blinking and you may
edit them with + or – buttons in 15 minute
steps. The UTC setting will be confi rmed by
pressing the SEL button.
3.1.3 Setting the time and 24h or
AM/PM mode
In the display above the current time is
shown on the display.
By pressing the SEL button the 24h or 12h
setting on the top row starts blinking. You may
change the setting by pressing + or – buttons.
By pressing the SEL button the time setting
will be activated: hours start blinking and
seconds will turn to 00. You may change
the hours with + or – buttons. By pressing
the SEL button the selection will change to
minutes and can be edited the new time
setting will be confi rmed by pressing the
SEL button.

NOTE: seconds cannot be edited;
they always start counting from 0.
3.1.4

Set dual time mode

CHROMIS USER MANUAL