Setting The Dual Depth Alarm; Setting The Depth Incremental Alarm; Setting The Dive Time Interval Alarm - SCUBAPRO-UWATEC Chromis User Manual

By pressing the SEL button the following
menu's can be accessed.
4.4.1

Setting the dual depth alarm

By pressing the SEL button at this menu
the on/off selection starts blinking. By
pressing + or - button this can be edited
and confi rmed by pressing SEL button.
After that the fi rst depth starts blinking.
By pressing + or - buttons you may select
the fi rst depth alarm from 5 to 100 meters
(20..330 feet). By pressing SEL the fi rst
value is confi rmed and the second depth
starts blinking. Like the fi rst, by pressing +
or - buttons the second depth alarm may
be set from 5 to 100 meters.

NOTE: The fi rst alarm is short
sequence for attention and the second
alarm is continuous. By setting the fi rst
alarm deeper than the second, it will
be masked by the continuous alarm
and you cannot hear the fi rst one.
CHROMIS USER MANUAL
4.4.2 Setting the depth
incremental alarm
By pressing the SEL button in this menu
the incremental mode starts blinking. By
pressing + or - the you may scroll between
the direction of the alarm or disable it with
selections: off, dn(down), up or both. After
confi rming the selection with SEL button
the alarm depth starts blinking. By pressing
+ or - buttons you may select the alarm
value from 5 to 100 meters (20..330 feet).
By pressing SEL button the alarm value will
be confi rmed.
4.4.3 Setting the dive time interval
alarm
By pressing SEL button at this menu the
function starts blinking and you may enable
or disable it by choosing on/off with + or
- buttons. After confi rming by pressing
the SEL button the time starts blinking. By
pressing + or - you can select the interval
from 15 seconds up to 10 minutes. By
pressing SEL again the selection will be
confi rmed.
25