DECORATIVE FACING
Any. noncombustible. material. may. be. used.
for facing (glass, tile, brick, etc.) as long as
the. proper. clearances. are. observed. (see.
Clearances, page 6). IMPORTANT: Louvered.
openings must not be obstructed, and upper
and.lower.panels.must.remain.removable.for.
PILOT/ELECTRODE ASSEMbLy ADjUSTMENT
The. pilot. assembly. is. factory. preset. for. the.
proper flame height. Alteration to these set-
tings. may. have. occurred. during. shipping.
and handling. If this is the case, some minor
adjustment.may.be.necessary.and.should.be.
done by a qualified technician. To access pilot
assembly, glass door must be opened. The
proper.settings.for.thermopile.height.should.
1/8"
(0.3 cm)
Figure 52 - Correct Pilot Flame Pattern
The air shutter, located at the base of the
main burner (see Figure 54), has been fac-
tory.preset.to.the.proper.air-to-gas.ratio.which.
results in an even, clean burning flame across
the.burner.(see.Figure.55)..If.readjustment.is.
necessary, you can restore the proper air-to-
gas.ratio.by.loosening.the.air.shutter.screw.
and. rotating. the. air. shutter. until. the. proper.
flame setting is achieved (the shutter's normal
setting.is.fully.open..Do.not.forget.to.retighten.
the.air.shutter.screw.
Air.Shutter Air.
Opening
Orifice
Firebox.Bottom
Figure 54 - Air Shutter Adjustment
6
FIREPLACE INSTALLATION
3/8" - 1/2"
(0.95 cm -
1.3 cm)
bURNER FLAME ADjUSTMENT
Burner
Adjustment.
Screw
Venturi.
Tube
Burner.Gas.Line
www.desatech.com
Continued
servicing. Use only heat resistant, noncom-
bustible. mortar. or. adhesive. when. securing.
facing.material.
Note: Combustible material, such as wood,
that has been fireproofed is not considered
noncombustible.
be at a distance of 3/8" to 1/2" from pilot flame
as.shown.in.Figure.5.
The. electrode. is. installed. at. the. factory. for.
proper positioning. However, alterations to
position.may.have.occurred.due.to.shipping.
and. handling.. These. settings. may. need.
adjustment and must be done by a qualified
technician..The.correct.position.and.height.is.
as.shown.in.Figure.53.
Edge.of.Burner
Figure 53 - Correct Ignitor Location
CORRECT
INCORRECT.
CLOSE.
SHUTTER
INCORRECT.
OPEN.SHUTTER
Figure 55 - Burner Flame Patterns
bURNER REMOVAL
CAUTION: Before proceeding
to open glass door or handle logs,
make sure entire unit is cool.
1.. Remove. top. and. bottom. louvers. and.
screen. assembly.. Undo. 4. latches. and.
open.glass.door.
3/4"
(19 mm)
Top.of.Burner
(Side View)
Long, Blue Flame with
Yellow.Tips
Short, Sharp, Blowing Flame
Long, Uneven, Yellow Flame
1/2"
(12.7 mm)
56131H