Table of Contents
Advertisement
Note for connecting the speaker cords to the receiver
: ; ,:I'.
Remove about IO mm of insulation at the end of the cord. then twist the exposed wires.
Connect the stripped ends of the cords to the terminals, taking care to avoid mutual contact
bctwecn the cords.
Make sure the cords are firmly connected to the speaker and receiver terminals.
To avoid short-circuiting the speakers
Short-circuiting
of the speakers may damage the receiver. To prevent this, be sure to follow
these precautions when connectinp the speakers. Make sure the bare wire of each speaker cord
does not touch another speaker terminal or the bare wire of another speaker cord.
Examples of poor conditions
of the speaker cord
Stripped speaker cord IS touching
Stripped cords are touching each other due to
another speaker terminal.
excessive removal of insulation.
,Zl'ccr
co~~ncc~~~~g
alI
the
L~OII~~OIICIIL~,
speakers. and AC power cord (mains lead), output a test
IOW
to chcc~l, that all the ~I>t~i~l\cr\ are connected correctly. For details
OII
outputting a test tone,
\ce page 17.
il. no sound i\
Iic';iixl
l'i.oln
21 ,,pcal\cr while outputtin g
ii
test tone, or a te\t tone is output from a
~XI,IY
other
tlx111
111~ ow
C~IITCIII~~
displayed
on
the front panel display. the speaker may be
,,horl-lriri~uilc(l.
!I iliii liapp~'i~\. :.hcc~I\ the \peakcr connection again.
Advertisement
Table of Contents
