Table of Contents
Advertisement
Troubleshooting
If you experience any of the following
difficulties while using the receiver, use this
troubleshooting guide to help remedy the
problem before requesting repairs. Should
any problem persist. consult your nearest
Sony dealer.
Power
The power is not turned on.
I)
Check that the AC power cord (mains lead) i\
connected securely.
There is no picture.
+
The
connecting
cords are not connected
securely.
+
The connecting cords are damaged.
+
The receiver is not connected to the correct
TV
input jack (page 22).
I)
The video input on the TV is not set so that
you can view pictures from the receiver.
+
You have set "COMPONENT
OUT" in
"SCREEN
SETUP'
to "PROGRESSIVE"
even though your TV cannot accept the signal
in progressive format. In this case, set the
COMPONENT
VIDEO
OUT/SCAN
SELECT switch on the back panel of the
player to INTERLACE.
Then set "COMPO-
NENT OUT" to "INTERLACE"
after you
can see the TV screen correctly, and reset the
COMPONENT
VIDEO OUT/ SCAN
SELECT switch to SELECTABLE.
+
Even if your TV is compatible
with
progressive format (480~) signals, the image
may be affected when you set "COMPO-
NENT OUT" to "PROGRESSIVE."
In this
case, set "COMPONENT
OUT" tn "INTER-
LACE."
+
When "PROGRESSIVE"
is selected in
"SCREEN
SETUP," no signal is output from
the MONITOR
jack.
Picture noise appears,
I)
The disc i\ dirty or flawctl.
I)
II' the picture output from y~our rcccr\cr got\
tht-ough your VCR to gcr to your TV. the
copy-protection
signal applied to some DVD
programs could affect picture qualny. II you
still experience problem\
CV~II when you
connect your rcceivcr dtrcctly to your TV. try/
connecting your rece(\ler IO yourTV'\
S
video input (page 22).
Even though you set the aspect ratio
in "TVTYPE"
of "SCREEN SETUP,"
the picture does not fill the screen.
+
The aspcc~ ratio of the dt\c ix lixed on your
DVD.
The picture is black and white.
3
Depending or the TV. the picture on the
xrcen
become\ black and white when you
play a dr\c recorded tn the NTSC coloi
system.
Sound
There is no sound.
-b
The connecting cord is nol connected
sccurcly.
W
The connecting cord i\ damaged. Replncc it
wtth a new one.
I,
Press MUTING
on the remote if"MUTING
ON" i\ displayccl on the front panel display.
*
The protcctivc device on the rccei\Jcr has
hccn itctivatcd bcciusc of :I sht)rt circuit. Turir
off the rccc~vcr. climinalc
the short-crrcurt
problem and turn on the lpowcr again.
*
The receiver i\ in pau\c mode or in Slow
motion Play mode. Prc\\ D
to return 10
IlOl.lllili
play mode
Advertisement
Table of Contents
