Avital 5103 Installation Manual page 53

Car security
Hide thumbs Also See for 5103:
Table of Contents

Advertisement

the parking lights will flash during the remote start runtime. In the OFF setting, the
parking lights will not come ON or flash, when the vehicle is remote started.
3-4 CRANK TIME 0.6/0.8/1.0/1.2/1.4/1.6/1.8/2.0/4.0 SECONDS:
If the unit is programmed for no engine checking or voltage sense, the crank
time must be set to the appropriate duration. The default setting is 0.6 second.
If a different crank time is desired, you can toggle through the higher settings by
using the two-chirp settings.
3-5 ACTIVATION PULSE 1: This allows the system to use 1 or 2 pulses to acti-
vate the remote start sequence. The default setting is 1-pulse.
Note: This setting affects both the White/Blue input wire and the remote con-
trol.
3-6 2nd IGNITION/ACCESSORY OUTPUT: This will allow the PINK/WHITE to
be used as a 2nd ignition or an accessory. The default is 2nd ignition.
3-7 ACCESSORY STATE DURING WAIT-TO-START OFF/ON: This feature will
allow the selection of the accessory output to be ON or OFF during wait-to-start
time period.
3-8 2nd STATUS OUTPUT NORMAL/REAR DEFOGGER LATCHED 10-MIN/
PULSE: This feature will allow selection of status output or a rear defogger mode
that turns on ten seconds after the vehicle has started if the vehicle interior tem-
perature is below 55 degrees F. The defogger mode has two selections, latched
or pulsed. Latched mode will only stay on for 10 minutes.
3-9 ANTI-GRIND ON/OFF: With the anti-grind On (default) the ground-when-
armed output will be active during remote start operation. If accessories such as
a voice module or window module are added to the unit, it may be necessary
to program this feature off.
3-10 DIESEL TIMER—WAIT-TO-START/15, 30, 45 SECONDS:
Default is
the H2/5 Gray/Black "Wait-to-Start" input control wire. This system has an
onboard timer so the "wait-to-start" control wire does not need to be connected.
The timer can be programmed to a 15, 30 or 45 second delay. This feature can
also be programmed using the Bitwriter® with a delay from 1 to 90 seconds.
53
© 2009 Directed Electronics. All rights reserved.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents