Avital 5103 Installation Manual page 20

H1/11 WHITE
This wire is connected to the (+) parking light wire in the vehicle. If the light flash
polarity jumper on the side of the unit, is moved to the opposite position (See Pro-
gramming Jumper section of this guide) this wire supplies a (-) 200 mA output.
Note: For parking light circuits that draw 10-amps or more, the internal jumper
must be switched to a (-) light flash output. (See Setting the light flash polarity
section of this guide.) P/N 8617 or a standard automotive SPDT relay must be
used on the H1/11 light flash output harness wire.
H1/12 ORANGE
This wire supplies a (-)500 mA ground as long as the system is armed. The out-
put ceases as soon as the system is disarmed. The orange wire may be wired
to an optional Directed Electronics 8618 starter kill relay.
20
(+/-) SELECTABLE LIGHT FLASH OUTPUT
(+) Positive Light Flash Output
WHITE H1/11
(+) LIGHT FLASH OUTPUT
(-) Negative Light Flash Output
WHITE H1/11
(-) LIGHT FLASH OUTPUT
(-) 500mA GROUND WHEN ARMED OUTPUT
© 2009 Directed Electronics. All rights reserved.