Avital 5103 Installation Manual page 22

Car security

Hide thumbs Also See for 5103:

Table of Contents

H2/3

VIOLET/BLACK

This wire provides 200 mA programmable output whenever the transmitter but-

tons controlling AUX 2 is pressed.

H2/4

GREEN/WHITE

This wire sends a 200mA negative pulse every time the remote start shuts down

or when the doors are locked. This can be used to pulse the arm wire of the

vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to the

arm wire.

H2/5

GRAY/BLACK

Connect this wire to the wire in the vehicle that sends the signal to turn on the

WAIT-TO-START bulb in the dashboard. In most diesels the wire is negative

(ground turns on the bulb) and the GRAY/BLACK wire can be directly connected

Sat mode,

to the wire in the vehicle. If the vehicle uses a positive wire (12V to turn on the

bank selector

bulb) a relay must be used to change the polarity.

Table of Contents