Operation Guide; Program Enable - SHOWTEC Scanmaster 1 User Manual

2. Operation Guide

GENERAL
This unit allows you to program 12 fixtures of 16 DMX channels, 30 banks of 8
programmable scenes, 6 chases of 240 programmed scenes using 8 faders and
other function buttons. Up to 8 scenes can be programmed into a bank, and the
amount of 240 programmed scenes can be stored into a chase and the scenes
can be triggered by Music, Auto, Tap Sync, MIDI and Manual.
Display Information
The Segment Display consists of 4 digits. The first digit shows the active chase
number(1-6), the second digit shows the active scene number(1-8), and the third
and forth digits show the active bank number(01-30).
During Auto mode, a highlight
" Auto trigger" indicates its selection.
During Music mode, a highlight in the upper right corner of the Segment Display next
to " Music trigger" indicates its selection.
During Blackout mode, a fast blinking light indicates its selection in the upper left corner
of the Segment Display next to " Blackout".
During Program mode, a fast blinking light indicates its selection in the lower left corner
of the Segment Display next to " PROG.".

2.1 Program Enable

Step/time
Blackout
Step
PROG
Chase Scene Bank
Program
7
in the lower right corner of the Segment Display next to
When the power is turned on, this unit enters
Music trigger
Manual mode automatically.
Auto trigger
Press the Program button for three seconds to
activate Program mode, a fast blinking light in
the Segment Display next to "PROG." indicates
its selection.