Outdoor Grill Care; Replacing The Igniter Battery; Changing The Light Bulb - Jenn-Air FREESTANDING OUTDOOR GRILLS Installation Instructions Manual

Replacing the Igniter Battery

If igniters stop sparking, the battery should be replaced.
1. Open cabinet door.
2. Unscrew igniter button cap counterclockwise to remove.
A. "AA" size battery
B. Igniter push button
3. Remove battery from the battery compartment.
4. Replace with a new alkaline "AA" size battery. Install battery
with negative end in first.
5. Screw igniter button cap clockwise into place.

Changing the Light Bulb

1. Unplug grill or disconnect power.
2. Make sure the light power switch on the control panel is in the
OFF position.
3. Use a Phillips screwdriver to loosen the two screws securing
the glass light cover to the grill hood.
A
A. Screws
B. Hood light cover
NOTE: When removing final screw from the glass light cover,
make sure to hold the cover in place, ensuring it doesn't fall
and shatter.
28

OUTDOOR GRILL CARE

A
B
B
4. Loosen the screw securing the light assembly to the grill
hood and pull out the light with glass light cover.
A
B
A. Screw
B. Light assembly
5. To remove glass light cover, remove screw and gently pry
downward with a small flat-blade screwdriver at the left edge
of the cover near the screw and pull away from the retainer.
6. Use a flat-blade screwdriver to remove the two screws
locking the bulb into place.
A. Screws
7. Remove bulb from socket.
A