MTD 550 Series Operator's Manual page 10

Edging Along A Curb
The right, rear wheel of the edger can be lowered into one of five
positions to ease the task of edging along a curb. To adjust the
height of curb wheel, proceed as follows:
1. Lower the right, rear wheel by moving the curb height
adjustment lever slightly to the left. See Fig. 5–2.
Curb Height
Adjustment
Lever
3

2. Pivot the right, rear wheel into an applicable position in
relation to the height of the curb to be edged along. See
Fig. 5–2
3. Release the curb height adjustment lever to lock the wheel
in position. See Fig. 5–2.
10 s 5— O
ectiOn peratiOn
1
Figure 5-
Beveling
In order to achieve a bevelled edge, set the bevel adjustment
lever (refer to the Assembly & Set-Up Section) in the first (left
hand) or third (right hand) notch to place the edger blade in
position for beveling (See Fig. 5–3).
Right-Hand Position
Figure 5-3
Left-Hand Position