Installation Of The Security System - PINKERTON User Manual

PINKERTON Quick Setup

Installation of the Security System

Step 1:
Plan out location of all components supplied in your kit as follows:
Suggested Locations for Equipment Mounting
The 8 Zone Master Panel Box should always be located out of sight (i.e.
(a)
cupboard, wardrobe or in an area it would not be easily seen).
The 8 Zone PINKERTON Keypad should be situated near the main entry/exit
(b)
point (usually inside the main front door).
The External Siren (enclosed in siren cover along with Tamper Button)
(c)
should be mounted in a prominent position in full view. This would normally
be mounted under the eaves at the front of the house in a corner position. The
strobe light is mounted onto the siren cover.
The Flush Mount Reed Switches are most suitable to be mounted on the front
(d)
and back doors.
The Passive Infra Red Detectors (PIR'S) should be situated to cover high
(e)
access areas (eg: Hallways and areas of high importance or value).
The Emergency Button should be located in a position for quick easy access
(f)
in an emergency or panic situation (suitable position could be a bedside
location).
The Pinkerton Security Alarm Warning Stickers should be placed on the front
(g)
face of the Siren cover and on an outside window in clear view.
Note: PIR's are susceptible to environmental conditions such as wind and air
movement. Windows must be closed when system is armed to avoid possible
false alarms.
Step 2:
Install all cabling to component positions.
(a)
Austel approved cables must be installed if the system is to be monitored.
(b)
Use two pair (4 core) 14/0.20 and Figure 8 (2 core) 14/0.20.
REMEMBER TO MARK YOUR CABLES.
2