Pinkerton Indicator Lights; Away Mode; Home Mode - PINKERTON User Manual

PINKERTON User Manual

PINKERTON Indicator Lights

Listed below are the use of the indicator lights when in normal operation.
Keypad Light ON
Light
On-Line Dialler on line
Low Batt Battery Charge Voltage Low
Power not connected
AC Fail
On Alarm is ON (Away mode)
Chime Mode is ON
Chime
Unsealed, Manual or Auto
Zone 1 - 8
isolated
Note that the status of the Zones will always be displayed unless disabled
by the installer. The Low Batt and AC Fail lights will show the current
state of these inputs, however the alarm (or restore) condition may have to
be present for a period before a report is initiated.
If the dialler fails to communicate, the On-Line light will remain flashing
until the next time the system is turned OFF.
All Zone lights on plus a continuous beeper
Means the keypad is locked out for 60 seconds caused by 4 consecutive
incorrect code entries.
All Zone lights flashing
Indicates a legal code has been entered (or the
keypad expects another key to be pressed to select the desired function
within 10 seconds.
To cancel simply wait 10 seconds or press the
Light OFF Light Flashing
Dialler not on line Dialler had problems
Battery OK Had Low Batt alarm
Power OK Had AC fail alarm
Alarm is OFF Alarm is ON (Home
mode)
Chime Mode is
OFF
Zone is sealed Had alarm
key pressed) and the
key.
10