Quick Setup & Installation; Factory Defaults - PINKERTON User Manual

PINKERTON Quick Setup
Quick Setup & Installation
Thank you for purchasing the PINKERTON Security Alarm System, the following is
intended to assist you in the installation of the system. Please read these guidelines
before installation.
Note: In some States of Australia special licensing may be required in order to
install Security Alarms and Associated Equipment. Please check with your
local State Authority for details before commencing installation work.
IMPORTANT:
This section is a brief outline of installation and programming. For additional
information refer to the PINKERTON Installer Manual.

Factory Defaults

THE PINKERTON ALARM SYSTEM COMES FROM THE FACTORY PROGRAMMED AND
READY TO GO. BEFORE MAKING ANY CHANGES, CHECK WHAT IS ALREADY
PROGRAMMED, AS THEY WILL MOST PROBABLY SUIT YOUR NEEDS.
MASTER USER CODE
INSTALLER CODE
ENTRY TIME
EXIT TIME
SIREN TIME
ZONE TYPE
NOTE: When Armed in Home Mode Zones 5 and 6 has been programmed to be
isolated.
: 1 2 3 4
: 2 5 8 0
: 30 seconds
: 60 seconds
: 5 minutes
: Entry Delay - enables entry exit timer.
Zone 1
: Handover - enables exit timer and entry timer
Zone 2
if Entry Delay Zone entered first.
: Handover - enables exit timer and entry timer
Zone 3
if Entry Delay Zone entered first.
: Instant - immediately sounds siren if violated
Zone 4
when system is armed.
: Instant - immediately sounds siren if violated
Zone 5
when system is armed.
: Instant – immediately sounds siren if violated
Zone 6
when system is armed.
: 24 Hour - sounds sirens if violated whether
Zone 7
system is armed or disarmed.
: 24 Hour - sounds sirens if violated whether
Zone 8
system is armed or disarmed.
1