Mantis 7566 Operator's & Parts Manual page 15

HOw TO SwiTcH FROM TiLLiNG TO cULTiVATiNG POSiTiON
1. First, you will need to understand that
your Mantis Deluxe XP Tiller has an
®
inner and an outer set of tines on each
side of the tiller as shown in Figure 1.
2. Make sure the tiller is turned off.
3. Remove the retaining pins from the
outer set of tines (Figure 2) and
remove the outer tines.
4. Only after you have removed the outer
set of tines, then remove the retaining
pins from the inner tines and remove
the inner tines from the transmission
axle (Figure 3)
iMPORTANT:
To change the tines on your Mantis
deluxe XP Tiller, push the tiller
forward and allow it to rest on the
loop handle.
Contact us at mantis.com or Your Local Authorized Mantis
401780 Mantis XP Deluxe tiller manual.indd 15
5. Place the right-side set of inner tines
onto the left-side. The "D" shaped
hole should be to the outside. Make
sure the tine retaining pin is installed.
Repeat for the other side
6. Place the right side set of outer tines
onto the left-side axle. The "D" shaped
hole should be to the outside and
insert the tine retaining pin. Repeat for
the other side.
Your Mantis Deluxe XP Tiller also has
®
the ability to till or cultivate at either a 9"
or 16" width. The tiller is sent to you set
up for 16". To run the tiller at a 9" width,
Figure 1
inner Tines
Outer Tines
Tilling
®
Handles
back
To set them for tilling, attach the tines
so the points of the blades face forward
- away from the operator. The tines'
points will contact the ground first.
Mantis Deluxe XP Tiller Operation
®
simply remove the inner and outer tines
as noted above. Then just put the outer
tines back onto the transmission axle and
secure with a retaining pin on each side.
Figure 2
cultivating
Tine
Rotation
Tine Teeth
Front
DO NOT reach your fingers and/or
hand between the tine blades.
dO NOT attempt to remove the
inner set of tines until you have
first removed the outer set of tines.
Figure 3
Handles
Tine Teeth
back
For cultivating, reverse the tines
so that the points of the tines face
backward - toward the operator. Now
the long flat part of the tine's blade
will contact the ground first.
Dealer
®
Tine
Rotation
Front
15
1/24/13 4:07 PM