Exhaust Pipe And Drain Pipe; Helpful Hints; Troubleshooting - Dimplex GDC-AC9RW Instructions For Use Manual

HELPFUL HINTS

The unit is fitted with a special thermal cut off device.
When selecting the refrigerating function, The unit should operate in
room temperatures between 17-32℃, and when selecting heating
function, the room temperature must less than 23℃ and above 7℃.
Please ensure the unit is not placed against objects which will
obstruct air intake e.g. furniture or curtains as this will affect it's
performance drastically.
Do not place the unit in direct sunlight, as this may cause the unit to
overheat and turn off.

EXHAUST PIPE AND DRAIN PIPE

To remove exhaust pipe, press slightly and pull away from the unit.
●
Picture indicates the removal of the exhaust pipe.
●
Made sure the exhaust pipe and the drain pipe to be extended to the
●
closest window.
12
TROUBLE SHOOTING
Never try to repair or dismantle the air conditioner unit yourself. Incompetent repairs
result in loss of warranty and can endanger the user and the property.
Problem Cause
The air No power supply.
conditioner does
not function.
The alarm light is on.
Timer function is active.
The air In direct sunlight.
conditioner does
Windows or doors open,
not seem to
many people or a heat
perform.
source in the room.
Dirty filter
Air inlet or air outlet blocked.
Room temperature lower
than the selected value.
The unit is noisy. Unit is not level.
The compressor The overheat protection is
does not work. probably activated.
The remote Distance too long.
control does not
Remote control signal not
function.
detected by the control
panel.
The batteries are drained
To correct problems not mentioned in the table and/or if the recommended solutions fail
to solve the problem, please contact an authorized service centre.
Solution
Connect to a functioning outlet
and switch on.
Empty the internal water
container.
Deactivate TIMER function.
Close curtains.
Close doors and windows, place
an extra air conditioner.
Clean the filter(s).
Remove the blockage.
Change temperature selection.
Place on an even, solid surface
(less vibrations.)
Wait 30 minutes until the
temperature has decreased, then
turn the unit on again.
Make sure the remote control is
correctly aimed at the control
panel.
Replace the batteries.
13