In-Bed Mount
1. Remove the tailgate from the vehicle.
2. Place the mount assembly into the bed of the
vehicle.
3. Slide the assembly forward engaging the locator
studs.
Locator
Studs
4. Secure the front of the mount assembly to the
channel using hold-down bolts. Hand tighten.
NOTE: Apply a small amount of grease to the bolt
thread periodically to ensure easy removal.
January 1, 2002
MOUNTING THE SPREADER
5. Lift the hopper assembly using a hoist or two
Mount
Assembly
6. Position the tabs of the hopper assembly over the
Hold-down
Bolt
7. Allow the hopper assembly to lower into position.
6
people, and tip slightly forward.
top of the mount assembly, and lower.
Tab
Lit. No. 13648/9511