Western PRO-FLO Owner's Manual page 12

3. Lift the hopper assembly using a hoist or two
people, and tip slightly forward.
CAUTION
Visually align tabs into the secondary frame.
4. Position tabs on the hopper assembly over the top
of the mount assembly, and lower the assembly.
January 1, 2002
MOUNTING THE SPREADER
5. Insert pin on each side and secure with hairpin
6. Connect spreader wiring harness to the vehicle
NOTE: Grease all electrical connections with
dielectric grease.
7. Verify proper stoplight and spreader operation.
8
cotter pin.
Hairpin Cotter Pin
CAUTION
Both hold-down pins must be in place and
secured with hairpin cotter pins. The hopper
assembly may become unstable if the pins are
not properly secure while the vehicle is in
motion. Never use a finger to check alignment.
wiring harness.
Hold-down Pin
Lit. No. 13648/9511