Table of Contents
Advertisement
REMOVE SHIPPING BRACKETS AND
LOCATE COMPONENTS
The spreader is shipped from the factory with its
components secured inside the hopper and the top
screen in place. Before installing the spreader, remove the
shipping brackets and top screen, and locate components.
1. Remove the 3/8" flanged cap screws and the
top screen brackets, and remove the top screen.
Retain the screen and fasteners for reinstallation.
2. Inside the hopper, remove the eight 3/8" cap
screws from the two shipping brackets that secure
the chute enclosure to the hopper. Set the chute
enclosure aside and discard the shipping brackets
and hardware.
Remove brackets.
3. Immediately install the provided 3/8" stainless
steel flanged cap screws in place of the shipping
bracket fasteners removed from the hopper.
4. Remove the two 5/16" lag bolts that fasten the
spinner deflector assembly to the pallet. Remove
the 1/4" hardware that fastens the shipping bracket
to the spinner deflector assembly. Set the spinner
deflector assembly aside and discard the shipping
bracket and hardware.
Lit. No. 31002/31004, Rev. 00
MOUNTING THE SPREADER
9
CHUTE ASSEMBLY
1. Install four of the provided 3/8" stainless steel
flanged cap screws through the spinner guard
holes into the rivnuts on the chute enclosure.
Left‑Side
Chute Pin Ear
2. Remove and retain the cable boot bracket, dust
cover, and fasteners. Install the left and right side
chute pin ears to the chute enclosure with six
provided 3/8" flanged stainless steel cap screws.
Reinstall the cable boot bracket and dust cover.
3. Set chute aside for installation after the spreader has
been installed on the vehicle.
Right‑Side
Chute Pin Ear
3/8" Flanged
Cap Screws
Spinner Guard
June 1, 2022
Advertisement
Table of Contents
