Primo Assembly - Primo Water OVAL XL Owner's Manual

Introduction

Primo Assembly

Resting the Primo in its final destination:
This product is heavy and not easy to more.
You must be careful when you move it to it's
final resting destination. 2-3 people are recom-
mended to move the outer shells.
First remove all inside components and move
the outer shell (lid and bottom) to the desired
location. Do not attempt to loosen the bands or
the hinge assembly. Placing this unit in a
metal stand or wood table will demand good
handling and many hands to do the work prop-
erly. Any mishandling will not be covered under
the warranty.
Firebox placement:
Your Oval firebox is manufactured as a one
piece unit. Notice the air vent in the front.
―Carefully‖ place the firebox inside the Oval
bottom with the vent holes aligning with the air
control vent of the Oval bottom. This is impor-
tant for proper air flow to your unit.
Placing the inside components:
Find the ceramic bottom plate and place into
the bottom of the firebox. The ceramic plate
puzzles into the base of the firebox with the
plate surface facing upward. Next, place the
bottom grate at the mid-base of the firebox with
the divider slots facing upward. These slots are
going to secure the Oval firebox divider which
is sold separately as an accessory.
Securing the screws of the band assembly:
Our factory ships units pre-assembled, but for
your benefit, please ensure that the screws are
tight at all times. Bent screws is a good sign,
but may loosen after some period of time. From
the heat, your bands may expand over time
and reduce it's ability to fit tightly on your
Primo. Check periodically and tighten as
needed.
13