BRAVILOR BONAMAT MATIC Quick Start Manual

The programming of the Matic is divided in two
levels:
1. Quantity of water (included in the user
instructions)
2. Other options
WARNING
n The lower hot plate will become hot during
Ó Ó
programming.
Ó Ó

Access level 1

P1 Adjusting the quantity of water (per cup)
You can adjust the quantity of hot water used to
brew the coffee. This is set to a standard amount
when the machine leaves the factory. If you think the
factory setting is supplying too much or too little wa-
ter, you can change the amount as follows:
1. Press the ã and the
and keep them pressed in until P1 appears in
the display (after about 10 seconds).
2. Release the keys. The display will now show the
setting for the current quantity of water. This
quantity varies from machine to machine, see
table 1 .
3. Press the ã key for more water or the
less.
4. The settings available range from 0, 2, 4, 6... to
98. Two steps higher will give you 3 to 5 ml.
extra water in the decanter, see table 1 .
5. Wait for about 20 seconds.
The machine is now ready for use again.
MATIC / THA
1
/ keys at the same time
0
1
/ key for
0
ECopyright Bravilor Bonamat B.V.

Level 1

P1 Quantity of water adjustment

Level 2
P2 Maximum Number Of Cups
P3 Default on display
P4 Masking Quantities
P5 Drip Time
P6 Display Options During Brewcycle
P7 Total amount
During programming
ã
1
/
0
ã
1
/ both
0
Keys Display
12
ã
1
/
0
P1
28
ã / ã / 1 1
/ /
0 0
34
12
+
Next option
Remark
Press both keys
Release keys
Adjust Adjust
Wait 20 sec.
Ready to brew