Advertisement
1
BAGGER SUPPORT ASSEMBLY
(See Figures 1A and 1B)
1. Remove rear engine guard (if installed) by
removing the six bolts that attach the guard to
the frame.
2. Place hitch Part No. 539113090 on the rear of
the mower.
ENGINE
GUARD
BOLTS
ENGINE
GUARD
BOLTS
FIGURE 1A
3. Install two (2) previously removed bolts
(539107475) thru rear of the hitch weldment.
4. Secure the sides of the hitch to the frame
with four (4) bolts (539107899) and four (4)
washers (539990598) two per each side.
BOLT, 5/16-18 X 3/4, GR8
WASHER, 1/4
PREVIOULY REMOVED
HARDWARE
FIGURE 1B
ASSEMBLY
REAR ENGINE GUARD
ENGINE
GUARD
BOLTS
HITCH
2
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY
(See Figure 2)
NOTE: For ease of assembly, you may wish to
obtain the assistance of another person for
mounting cover assembly to mower.
1. Position cover assembly on ground behind
mower as shown.
2. Lift and rotate cover to align cover brackets
with support assembly tubes.
3. Slide cover assembly down onto the support
tubes.
COVER
ASSEMBLY
FIGURE 2
SUPPORT
ASSEMBLY
7
Advertisement
