Egress Tagging Rules; Egress Settings; Summary Of Vlan Function - KTI Networks KGS-810F User Manual

Web smart 8-port gigabit ethernet switch with 1 mini-gbic port

Table of Contents

3.3.8 Egress Tagging Rules

Egress Tagging rules are used to make change to the packet before it is stored into egress queue of an egress

port. Three egress settings are provided for each port and are described as follows:

Insert Tag (per port setting)

Enable -

Insert the Tag data of the associated Packet Tag information into the packet

Disable -

No tagging is performed.

Untagging Specific VID (per port setting)

Enable -

No tag insertion if the VID data of the associated Packet Tag information matches the Untagged

VID configured in next setting even [Insert Tag] is enabled.

Disable -

This rule is not applied.

VLAN Modes

Port-based VLAN Mode: simple port-based 2-VLAN-groups mode

Port-based VLAN ISP Mode: simple port-based 5-VLAN-groups mode

Advanced VLAN Mode: Full VLAN configuration for port-based and Tag-based VLAN

Advanced VLAN Mode

Egress Settings (per port): [Tag Aware], [Keep Tag], [Drop Untag], [Drop Tag]

Ingress Default Tag (per port): [PVID], [CFI], [User Priority]

VLAN Groups (global): 8 VLAN groups

VLAN Group Settings (per group): [VID], [Member Ports], [Source Port Check]

Egress Settings: [Insert Tag], [Untagging Specific VID], [Untagged VID]

VLAN range supported: 1 ~ 4095 (eight VLANs at the same time)

[PVID] [VID] [Untagged VID] value range: 1 ~ 4095

-24-

Table of Contents