Table of Contents
Advertisement
2.9 LED Indication
LED
POWER
MGT
LNK/1000M/ACT
LNK/100M/ACT
LNK/10M/ACT
FX8
2.10 Configuring IP Address and Password for the Switch
The switch is shipped with the following factory default settings for software management:
IP address of the switch: 192.168.0.2 / 255.255.255.0
Default
The IP Address is an identification of the switch in a TCP/IP network. Each switch should be designated a new
and unique IP address in the network. Refer to Web management interface for System Configuration.
The switch is shipped with factory default password 123 for software management.
The password is used for authentication in accessing to the switch via Http web-based interface. For security
reason, it is recommended to change the default settings for the switch before deploying it to your network.
Refer to Web management interface for System Configuration.
Function
State
Power status
ON
OFF
Management status OFF
ON
Port link status
ON
BLINK Port link is up and there is traffic.
OFF
Port link status
ON
BLINK Port link is up and there is traffic.
OFF
Port link status
ON
BLINK Port link is up and there is traffic.
OFF
FX8 status
OFF
ON
Interpretation
The power is supplied to the switch.
The power is not supplied to the switch.
The switch is in initialization.
The switch is initialized completely.
A 1000Mbps link is established. (No traffic)
Port link is down.
A 100Mbps link is established. (No traffic)
Port link is down.
A 10Mbps link is established. (No traffic)
Port link is down.
RJ-45 copper connection is selected on Port 8.
SFP fiber connection is selected on Port 8.
-17-
Advertisement
Table of Contents
