Dell Latitude C610 Service Manual page 34

Display Assembly, Display Latch, and Hinge Covers: Dell Latitude C610/C510 Service Manual
1. Remove the hard
2. Remove the display
3. Remove the display
4. Remove the hinge
5. Remove the two M2 x 4-mm screws on the left side of the display panel and the two M2 x
4-mm screws on the right side of the display panel.
NOTE: If you have a Hitachi display panel, remove the two M2 x 4-mm screws from the
center of the left side of the display panel.
6. Remove the M2 x 4-mm screw that secures the display-feed flex cable to the display
assembly through the black plastic flex-cable retention bracket (see
Bezel and Panel").
7. Lift from the top and rotate the display panel out of the top cover.
8. Disconnect the bottom flex cable connector from the inverter connector by pulling straight
up on the attached pull tab (see
Display-Feed Flex Cable Connections
file:///F|/Service%20Manuals/Dell/Latitude/c510-610/display.htm (6 of 12) [2/28/2004 7:55:49 AM]
drive.
assembly.
bezel.
covers.
"Display-Feed Flex Cable
"14.1-Inch Display
Connections").