Table of Contents
Advertisement
Wake-Up Event Setup
Wake-Up by PCI Card
Enabled
Disabled
The system will not wake up despite access to the PCI
card.
Power On by Ring
Set this field to Enabled to use the modem ring-on function. This will
allow your system to power-on to respond to calls coming from an
external modem.
Wake Up On LAN
Set this field to Enabled to allow the network to remotely wake up
a Soft Power Down (Soft-Off) PC. However, if your system is in the
Suspend mode, you can wake up the system only through an IRQ
or DMA interrupt.
Resume By Alarm
Enabled When Enabled, you can set the date and time you
would like the Soft Power Down (Soft-Off) PC to
power-on in the "Date (of Month) Alarm" and "Time
(hh:mm:ss) Alarm" fields. However, if the system is being
accessed by incoming calls or the network (Resume On
Ring/LAN) prior to the date and time set in these
fields, the system will give priority to the incoming calls
or network.
Disabled Disables the automatic power-on function. (default)
This field should be set to Enabled only if your PCI
card such as LAN card or modem card uses the PCI
PME (Power Management Event) signal to remotely
wake up the system.
card will cause the system to wake up.
card's documentation for more information.
Access to the LAN card or PCI
3
BIOS Setup
Refer to the
8 7
Advertisement
Table of Contents
