Changing The Water Filter - Electrolux EBE5007 User Manual

CHANGING THE WATER FILTER

IMPORTANT
•
Always fit the filter as per
manufacturer's instructions.
•
If you need to replace water tube, only use
approved water quality piping that meets the
pressure requirements.
•
Make sure your refrigerator is level to avoid
uneven ice cubes.
•
Replace filter at suggested intervals to avoid
water/ice reduction and irregularities in taste.
•
Remove and clean ice bin once a month,
discarding unused ice cubes. This will ensure fresh,
clean ice and smooth operation of your ice maker.
•
Clean and empty the dispenser drip tray regularly
to avoid overflow.
WARNING
•
Use the appliance with water filter supplied by
Electrolux Home Products Pty Ltd or its authorized
service agent only.
•
For correct operation of this appliance it is
essential to observe the manufacturer's instructions
NOTE: A backflow prevention device compliant to
AS/NZS 2845.1 for low hazard situations must be
installed upstream of the connection in accordance
to NCC volume 3.
Internal Water filter
The water filter is located at the top left side of the fresh
food compartment.
Replacing the water filter
You should change the water filter every six months to
ensure the highest possible water quality.
If your refrigerator has not been used for a period of
time (during a house move for example), change the
filter before reinstalling the refrigerator.
It is not necessary to turn the water supply off to
change the filter. Be ready to wipe up any small
amounts of water released during the filter replacement.
1. Ensure that the ice maker is turned off (Diagram 1).
2. Remove the filter by turning anti-clockwise 180˚.
3. Slide the old water filter cartridge straight out of the
housing and discard it. (Diagram 2).
4. Unwrap the new filter cartridge and using the
alignment guide, slide it gently into filter housing
until it stops against the filter connection at the back
of the housing. (Diagram 3).
5. Engage the filter by firmly rotating clockwise until
the filter snaps into position (once engaged the filter
cannot be rotated further). (Diagram 4).
6. Press a drinking glass against the water dispenser
while checking for any leaks at the filter housing. Any
spurts and sputters that occur as the system purges
air out of the dispenser system are normal.
7. After filling one glass of water, continue flushing t he
system for about four minutes.
8. Turn on the ice maker. (Diagram 5).
9. When the filter has been replaced press and hold
the 'Ice and Water' button for three seconds to
reset the filter replace timer.
D D i i a a g g r r a a m m 1
D D i i a a g g r r a a m m 2
e r c u o S e u r
e r c u o S e u r
e r c u o S e u r
2 a r l t
2 a r l t
2 a r l t
m e s t S y n i o a t t r F i l e r a t W
m e s t S y n i o a t t r F i l e r a t W
D D i i a a g g r r a a m m 3
m e s t S y n i o a t t r F i l e r a t W
D D i i a a g g r r a a m m 4
D D i i a a g g r r a a m m 5
P
P
P
U
U
U
& e I c
& e I c
& e I c
15