DEC a-Series Installation And Setup Manual page 28

Setting Up an Operating System
Digital Personal Workstation 500 au Firmware Update V6.78
Use HELP or ? for help
Update
VERIfy
List
Show
DUmp
VERBose
NVerbose
DEbug
NDebug
?
Apu->
4. To update the firmware, type update and SRM. The following information is
displayed as the firmware is being updated. The actual information may change
between versions.
Apu-> update SRM
APU-I Are you ready to Program (SRM) ROM Device? (Y/N)Y
APU-I Erasing (SRM) ROM device
APU-I Programming (SRM) ROM device
APU-I Verify loaded (SRM) ROM image
APU-I Verify loaded (SRM) ROM image done
APU-I Programming (SRM) ROM completed
APU-I Verify SRM
SRM ROM verify successful
Apu-> Verbose
Verbose :Apu-> Verify SRM
Version = v6.7-250
5. To exit the update utility, cycle the power. Leave the power off for at least 45
seconds.
NOTE: Commands such as Dump , List , Show, and Verify must have verbose mode
enabled.
2–8 Installation and Setup Guide