Thermostat; Auto Swing; Horizontal Air Flow Adjustment (Automatically) - Fortress Technologies FWAC08M13 User Manual

OPERATION INSTRUCTION

THERMOSTAT

THERMOSTAT
TEST MODE

AUTO SWING

Horizontal air flow adjustment (automatically)

Thermostat
The thermostat is used to set the desired room
temperature when the unit is being operated in
the COOL MODE.
To set the desired room temperature, rotate the
thermostat knob to the desired setting. After
the set temperature is achieved the thermostat
will automatically start and stop the compressor
in order to maintain the desired set temperature.
COOLER
Rotate the thermostat knob clockwise for
higher cool settings. Higher cool settings will
provide lower room temperature. Rotate the
thermostat knob anticlockwise for lower
cool settings. Lower cool settings will provide
higher room temperature.
NOTE:
1. After rotate the thermostat knob to adjust the cool settings
during operation in cool mode, do not rotate it again in 3 minutes
otherwise the fuse may blow due to an overload of the unit.
2. Between 9~12 set points is the lowest temperature operation
mode, 12 set point is TEST MODE.
Caution: TEST MODE is designed for factory testing only,
evaporator freeze up may occur when unit continues operating
at TEST MODE,DO NOT SELECT TEST MODE DURING
NORMAL OPERATION!
When the AUTO SWING switch is turned to
position, the vertical louvers automatically oscillate
right and left sweeping the cold air alternately to
obtain comfortable cooling. The vertical louvers will
be stopped at any position when the AUTO SWING
switch is turned OFF .
OFF
7
AUTO SWING
ON
ON